B200K5TY15

Introduction

•With forward and reverse rotating, start and stop, speed regulation and full speed functions.
•RS485 communication, support MODBUS protocol, a variety of communication parameters can be set, easy to connect with various control equipment.
•TY15 spring easy-install pump head adopts a quick-installations structure design, flexible upper pressure block, spring roller structure, and convenient and quick tube installation;
•Small and compact with an attractive and aesthetically pleasing design
•Long service life of tubes;
•Quiet operation;
•Good mechanical strength and resistance to pollution;
•Suitable for small and medium flows;
•Suitable for COD and CEMS online monitoring usage;
•To facilitate use in ODM (Original Design Manufacturer) support ,it is designed to be compatible with various devices, instruments, and laboratory settings.

Pump Parameters

Motor Types: 57 stepper motor
Power Supply Voltage: DC 24-36V
Control Mode: RS485 communication
Communication Mode: RTU
Communication Address: 1- 16
Communication Rate: 9600
Data Bit: 8
Check Bit: Parity check/No parity check
Stop Bit: 1
Speed Range: ≤200rpm
Flow Rang: ≤280mL/min
Channel Number: 1 Channel
Roller Number: 2 rollers
Running Direction: Clockwise/Counterclockwise rotation
Tube Material: Silicone, Pharmed, A-60-G
Tube Installation Method: Tube connector
Type of Tube Pressure: Fixed gap
Pump Head Shell Material: IXEF
Material of Pump Head Roller: PET+PPS
Material of Pump Head Pressure Block: PVDF
Material of Roller Shaft: S304 Stainless Steel
Life Span: ≥1000h
Noise: ≤ 60db (testing environment noise ≤40dB, horizontal distance between test product and noise meter is 1 meter)
Driver Weight: 0.42Kg (without tube)
Dimensions(L*W*H): 137mm*82mm*82mm
Wattage: <30W
Working Environment: Temperature 0- 40°C, , Relative humidity＜ 80% RH
Storage Environment: In a clean and well-ventilated environment with ambient temperatures ranging from -40 to +50°C, and relative humidity not exceeding 95%, the air must not contain corrosive, flammable gases, oil mist, or dust.

Applicable Tube Model and Flow Reference Table

Model	Tube Material	Tube No.	Flow Rate (mL/min)
Model	Tube Material	Tube No.	1rpm	10rpm	100rpm	200rpm
B200K5TY15	Silicone	25#	1.4	14	140	280

The above flow data were all tested using a Lead Fluid silicone tube to pump pure water under laboratory conditions with normal temperature and pressure.
This data is for reference only. Due to pressure in actual use , temperature, medium characteristics, tube material and other specific factors, the specific situation needs to consult our engineers.

Pump Structure and Use Method

Component Names and Functions:
1.TY Pump Head: Attach a tube for liquid transfer;
2. Mounting Plate: This component connects the motor to the pump head and also allows the product to be mounted onto other equipment;
3. Motor: Provides power;
4. Drive Unit: Controls the motor speed and start/stop functions using external analog signals.

Usage Method
Disassembling the TY15 pump head
Step 1: Push the upper pressure plate lock using the direction indicated by the arrow on your finger, then open the upper pressure plate.
Step 2: Hold the latches on both sides and move them upward to open the unit, then remove part number 1, the “upper pressure block,” as shown in Figure 3.
Step 3: Detach the tube joint as illustrated in Figure 4.